IBM RS/6000 SP, Maintenance Information

Page: 95 / 388

MAP 0170: Thin Processor Node Control
003 (continued)
Was mode originally in SERVICE position as noted in previous step?
Yes No
004
Customer may have tried to reset processor node in SECURE mode. Reset will only take
effect in NORMAL or SERVICE modes.
– From the control workstation, reset this processor node.
Does processor node reset?
Yes No
005
Problem with reset.
– Go to Step 012 on page 1-76.
006
No problem found.
– Inform customer that the processor node will not reset if the mode switch is in the SECURE
position.
– Go to “MAP 0570: End of Call” on page 1-357.
007
– From the control workstation, issue reset for this processor node.
Does processor node reset?
Yes No
008
Problem with reset.
– Go to Step 012 on page 1-76.
009
Intermittent problem may be occurring.
– Please record following:
Ÿ Node number
Ÿ
Date / Time fault reported
Ÿ
Type of fault reported
– Check logs to see if this fault has been previously recorded.
Is this a recurring fault?
Yes No
010
This is not a recurring fault.
– Go to “MAP 0570: End of Call” on page 1-357.
011
Reoccurrence of intermittent fault has been detected.
(Step 011 continues)
Chapter 1. Maintenance Analysis Procedures (MAPs)
1-75