IBM RS/6000 SP, Maintenance Information

Page: 97 / 388

MAP 0170: Thin Processor Node Control
018 (continued)
Does this test indicate a failure?
Yes No
019
– From the control workstation, reset this processor node.
Does processor node reset?
Yes No
020
Problem with reset.
– Go to Step 024 to continue service with the next highest priority component.
021
Node reset and mode switches functioning properly.
Was this a solid problem? (If the problem was cleared by power-on only, answer No.)
Yes No
022
This is an intermittent problem.
– Please record following tracking information:
Ÿ Node number
Ÿ
Date / Time fault reported
Ÿ
Type of fault reported
Ÿ Action taken or component replaced
– Go to “MAP 0570: End of Call” on page 1-357.
023
Problem resolved.
– Go to “MAP 0570: End of Call” on page 1-357.
024
Problem with reset or mode switch function.
– From the control workstation power off processor node.
– Place processor node in service position.
– Remove processor node from frame, then remove top cover of processor node.
– Refer to the following table for priority of repair or replacement of components.
Chapter 1. Maintenance Analysis Procedures (MAPs)
1-77