IBM RS/6000 SP, Maintenance Information

Page: 117 / 388

MAP 0200: Processor IPL Problem
012 (continued)
– Go to Step 003 on page 1-95 to continue service.
013
Diagnostics pass for both SCSI port and boot disk.
– Refer to "Basic Stand-Alone Mode (From Network Boot) in
IBM RS/6000 SP: Maintenance Information,
Volume 3, Locations and Service Procedures to exit from the verification menu.
– Change boot response to “disk”, using "Selecting a Processor Node Boot Response" in IBM RS/6000
SP: Maintenance Information, Volume 3, Locations and Service Procedures.
Did you replace the boot disk?
Yes No
014
– From the control workstation, power off and on this processor node.
Does this processor node IPL?
Yes No
015
Probable software problem (AIX image on boot disk may not be functional).
– Call next level of support.
016
– Go to Step 017.
017
Hardware problem resolved.
– Inform the customer to use the appropriate procedures in
IBM RS/6000 SP: Administration Guide to
reinstall (or recover) an AIX image on the fixed disk.
– Remove processor node from service position.
– Reconnect all cables at rear of the processor node.
– Go to “MAP 0570: End of Call” on page 1-357.
Chapter 1. Maintenance Analysis Procedures (MAPs)
1-97