IBM RS/6000 SP, Maintenance Information

Page: 169 / 388

MAP 0280: 604 or 604e High Node Minimum Configuration
007 (continued)
– Go to “MAP 0570: End of Call” on page 1-357.
008
No failure was detected with this configuration.
– Set the circuit breakers to the Off (‘0’) position.
– Starting with the CPU cards, install one additional CPU card (CPU) or memory card (MC) (if any).
– Set the circuit breakers to the On (‘1’) position.
– Wait for one of the following conditions to occur:
Ÿ The Maintenance Menu is displayed.
Ÿ The same three digit number is displayed in the operator panel display for longer than three minutes
except for the number ‘165’ which may display for up to ten minutes with no activity on the BUMP
console.
Ÿ
The number ‘888’ or ‘---’ is in the operator panel display.
Is the maintenance menu displayed?
Yes No
009
– Go to Step 011.
010
– Repeat Step 008 until all CPU cards (CPU) and all memory cards (MC) are installed and tested.
– After all CPU cards (CPU) and all memory cards (MC) are installed and tested, set the circuit breakers
to the Off (‘0’) position.
– Install the SCSI adapter.
– Connect the SCSI cable from the SCSI adapter to the SCSI connector.
– Go to Step 020 on page 1-151
011
The failure may be caused by the last CPU card (CPU) or memory card (MC) installed.
– Set the circuit breakers to the Off (‘0’) position.
– Exchange the last card installed (CPU or memory).
– Set the circuit breakers to the On (‘1’) position.
– Wait for one of the following conditions to occur:
Ÿ The Maintenance Menu is displayed.
Ÿ The same three digit number is displayed in the operator panel display for longer than three minutes
except for the number ‘165’ which may display for up to ten minutes with no activity on the BUMP
console.
Ÿ
The number ‘888’ or ‘---’ is in the operator panel display.
Is the maintenance menu displayed?
Yes No
012
– Go to Step 014 on page 1-150.
013
(Step 013 continues)
Chapter 1. Maintenance Analysis Procedures (MAPs)
1-149