IBM RS/6000 SP, Maintenance Information

Page: 131 / 388

MAP 0230: Wide Processor Node Control
003 (continued)
Was mode originally in SERVICE position as noted in previous step?
Yes No
004
– Customer may have tried to reset processor node in SECURE mode. Reset will only take
effect in NORMAL or SERVICE modes.
– From the control workstation, reset this processor node.
Does processor node reset?
Yes No
005
– Problem with reset.
– Go to Step 012 on page 1-112
006
– No problem found
– Inform customer that the processor node will not reset if the mode switch is in the SECURE
position.
– Go to “MAP 0570: End of Call” on page 1-357.
007
– From the control workstation, issue reset from this processor node.
Does the processor node reset?
Yes No
008
– Problem with reset.
– Go to Step 012 on page 1-112.
009
– Intermittent problem may be occurring.
– Record the following:
Ÿ Node number
Ÿ Date / Time fault reported
Ÿ Type of fault reported.
– Check logs to see if this fault has been previously recorded.
Is this a recurring fault?
Yes No
010
– This is not a recurring failure.
– Go to “MAP 0570: End of Call” on page 1-357.
011
(Step 011 continues)
Chapter 1. Maintenance Analysis Procedures (MAPs)
1-111