IBM RS/6000 SP, Maintenance Information

Page: 127 / 388

MAP 0220: Wide Processor Node Power
015
– From control workstation or processor node, check Power (green) LED for this node.
Is Power (green) LED Off?
Yes No
016
Processor node problem resolved.
– Go to “MAP 0570: End of Call” on page 1-357.
017
– Check processor node(s) on any other dc power harness for any that are powered on. Ensure that the
other processor node has its circuit breaker in the On (‘1’) position.
– Check the Power (green) LED for an On or Flashing condition.
– Processor nodes receive 48-volt power through one of four power harnesses. The sets of processor
nodes are as follows:
PDU-BH-P1: Processor nodes 1, 2, 3, 4
PDU-BH-P2: Processor nodes 5, 6, 7, 8
PDU-BH-P3: Processor nodes 9, 1ð, 11, 12
PDU-BH-P4: Processor nodes 13, 14, 15, 16
Is the Power (green) LED on any other processor node On or Flashing?
Yes No
018
– Go to “MAP 0370: Main Power” on page 1-222.
019
– Check all other processor nodes on the same dc power harness as the failing processor node to check
for the same symptom - circuit breaker on but Power (green) LED not lit.
Is this the only processor node showing this symptom?
Yes No
020
Problem with 48 V dc power distribution.
– Go to “MAP 0480: Open in 48 V dc Distribution” on page 1-283.
021
– Check cable connection at processor node tailgate N00-BH-J8 for a good connection.
Is there a good connection?
Yes No
022
– Fix cable connection problem.
– Go to Step 015.
023
– Go to Step 024 on page 1-108
Chapter 1. Maintenance Analysis Procedures (MAPs)
1-107