NO TICE
l
If the
MGMT
port on the active MM910 is already connected with a network cable, do
not remove the network cable from the
MGMT
port. Otherwise, an active/standby
switchover of the MM910s will be triggered, which may cause network interruption.
l
If you want to connect your local PC directly to the MM910 using a network cable but the
MGMT
port on the active MM910 is already connected with a network cable, connect the
network cable from the local PC to the
STACK
port of the active MM910 in the chassis. If
the
STACK
port on the active MM910 is also used, connect the network cable to an idle
STACK port on an active MM910 in a chassis cascaded with the E9000 chassis.
Step 2
Use TFTP or other tools to set up the TFTP server. The TFTP server directory is
c:\ftp
. Place
the switch module upgrade package in this directory.
Figure 6-24
Setting up the TFTP server
Step 3
After the switch module is powered on or reset, log in to the switch module serial port over
SOL. For details, see "Logging In to a Compute Node or a Switch Module over MM910
SOL" in the
MM910 Management Module V100R001 User Guide
. Press
Ctrl
+
B
to access
U-Boot.
E9000 Server
User Guide
6 Parts Replacement
Issue 25 (2019-11-30)
Copyright © Huawei Technologies Co., Ltd.
123
