Fuji Xerox apeosport-iv C3370, Administrator'S Manual

Page: 363 / 889

Authentication/Security Settings
363
T
ools
5
„
Hide Job Details
This feature is displayed when [Allow Job Viewing at All Times] or [Require Login to View
Jobs] is selected.
Select either [No] or [Yes].
Overwrite Hard Disk
Select whether or not to conduct hard disk overwriting.
When copy, fax, scan, or print processing is completed, the data is deleted from the hard
disk and the area on which the deleted data was stored is automatically overwritten with
blank data. This feature prevents unauthorized retrieval or restoration of the data recorded
on the hard disk. It also applies to copy document and other information stored
temporarily by the system. The following option can be configured.
Note
z
To perform the Overwrite Hard Disk feature, an optional component is required. For more information,
contact our Customer Support Center.
Number of Overwrites
You can set the number of overwrites.
Important
z
If the machine is turned off during the overwriting, unfinished files may remain on the hard disk. The
overwriting will resume if you turn the machine on again with the unfinished files remaining on the hard disk.
z
Overwriting once erases the data, but overwriting three times makes it even more definite that the data
cannot be restored. It does, however, take longer.
z
During overwriting, normal operations may be slowed down.
Note
z An optional component is required to use this feature. For more information, contact our Customer Support
Center.
Reference
z
For more information on how to check the status during overwriting, refer to "Overwrite Hard Disk" (P.363).
Prerequisite for Using the Data Security Feature
The system administrator must follow the instructions below:
z To protect the data deleted from or stored on the hard disk, the following settings are
required:
- Number of Overwrites: [1 Overwrite] or [3 Overwrites]
- Data Encryption: [On]: an encryption key of 12 digits
- Service Representative Restricted Operation: [Yes]
z Change the system administrator’s factory default passcode (x-admin). Register a new
passcode of 7 characters or more (maximum 12 characters). Be careful not to register a
passcode that can be easily assumed and not to store the registered passcode on a
location that is easily accessible to other persons.
Important
z If the system administrator's user ID and passcode are forgotten, the machine configuration will not be able
to recover in case of malfunction.
z Set [Passcode Entry for Control Panel Login] to [On].
z
Set [Maximum Login Attempts by System Administrator] to 5 times.