Fuji Xerox apeosport-iv C3370, Administrator'S Manual

Page: 662 / 889

Problem Solving
662
Pr
oblem
Solv
ing
15
124-364 [Cause] The machine restarts automatically.
[Remedy] No measure is required.
124-380
124-381
124-382
124-383
124-390
124-391
124-392
124-393 [Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
124-701 [Cause] The output destination was changed because of the
malfunction of the specified output tray (Side Tray).
[Remedy] Contact our Customer Support Center. You can use any output
trays other than the defective output tray.
124-702 [Cause] The output destination was changed because of the
malfunction of the specified output tray (Finisher Tray).
[Remedy] Contact our Customer Support Center. You can use any output
trays other than the defective output tray.
124-705 [Cause] The punch setting was cancelled.
[Remedy] Confirm the punch position, and then execute the operation
again.
124-706 [Cause] The folding setting was cancelled.
[Remedy] Confirm the folding setting, and then execute the operation
again.
124-708 [Cause] The output destination has been changed to the Center Tray or
the Finisher Tray. The probable causes are as follows:
1) Paper of a different size from the specified is loaded for 2
sided copying.
2) The Punching feature of the Finisher has malfunctioned.
[Remedy] For 1), check whether the specified size paper is loaded in the
tray.
For 2), confirm whether the error code 012-231, 012-232, 012-
233, or 012-234 is displayed on the touch screen, and contact
our Customer Support Center.
124-709 [Cause] The document exceeded the maximum number of pages that
can be stapled.
[Remedy] Reduce the number of pages, or cancel the stapling setting,
then try printing again.
124-710 [Cause] The machine cannot output to the output destination specified.
A paper size or a paper type that cannot be output is specified
or the output destination fails.
[Remedy] No measure is required. The machine automatically selects the
available output destination. If the paper is not still output from
the specified output destination even after the correct paper
size and type is selected, contact our Customer Support Center.
Error Code Cause and Remedy