Festo SFC-DC series, Manual

Page: 77 / 202

4. Control panel (only type SFC−DC−...−H2−...)
4−15
Festo P.BE−SFC−DC−IO−EN en 0801a
[Position set] Teach mode for programming the position set table.
Warning
During the teach procedure for specifying the target
position, the motor turns or the connected drive starts to
move.
·
Make sure that nobody can place his/her hand in the
positioning range of the moveable mass and that no
objects lie in its path.
[Position set] Param. Manual
[Position no.] no. Number of the position set
[1...31]
[Pos set mode] [absolute/
relative] Positioning mode
absolute = absolute position
specification, related to the
project zero point
relative = relative position
specification, related to the
current position
[Position] xt Target position in [mm]
[Velocity] v Positioning speed in [mm/s]
[Acceleration] a Acceleration in [mm/s
2
]
[Deceleration] d Deceleration in [mm/s
2
]
[SAVE...] Save parameter in EEPROM
Please note
The set parameters become effective immediately after
confirmation with OK <ENTER>. The settings are saved
permanently in EEPROM with the menu command
[SAVE...]:
·
Save the parameter settings with [SAVE]. Only then will
the settings be retained even if the power supply is
switched off or if there is a power failure.