Festo SFC-DC series, Manual

Page: 72 / 202

4. Control panel (only type SFC−DC−...−H2−...)
4−10
Festo P.BE−SFC−DC−IO−EN en 0801a
[System paramet.] Menu command for displaying the following system para
meters and data:
[System paramet.] Manual
VRef [V] Internal reference voltage
VDig [V] Digital voltage
Imax [A] Maximum possible motor current
(e.g. power limitation / motor protection)
Iact [A] Current motor current
Temp [°C] Operating temperature, power end stage
Cycle Number of positioning cycles
In−signal Hexadecimal representation of the inputs
Bit 0:
I1 (position set coding Bit 0)
Bit 1: I2 (position set coding Bit 1)
Bit 2: I3 (position set coding Bit 2)
Bit 3: I4 (position set coding Bit 3)
Bit 4: I5 (position set coding Bit 4)
Bit 5: STOP
Bit 6: ENABLE
Bit 7: START
Out−signal hexadecimal representation of the outputs
Bit 0:
MC (Motion Complete)
Bit 1: READY
Bit 2: ACKNOWLEDGE
Bit 3: ERROR
Ref. switch on/off Signal at reference switch input
Mode mm Measurement system (millimetre)
Hom.meth. bl.pos
bl.neg
sw.pos
sw.neg Fixed stop in positive direction
Fixed stop in negative direction
Reference switch in positive direction
Reference switch in neg. direction
Gear e.g.4.38 Gear ratio of the drive