Festo SFC-DC series, Manual

Page: 69 / 202

4. Control panel (only type SFC−DC−...−H2−...)
4−7
Festo P.BE−SFC−DC−IO−EN en 0801a
Menu command Manual
}
Diagnostic Display of the system data and the currently effective settings (see chapter 4.2.2)
}
Pos. set table Display the position set table
}
Axis parameters Display axis parameters and data
}
System paramet. Display system parameters and data
}
SW information Display the operating system version (firmware)
}
Positioning
1) 2)
Reference run and positioning run for testing the position sets (see chapter 4.2.5)
}
Homing Start reference run
1)
}
Move posit. set Start positioning run Position set"
}
Demo posit. tab Start positioning run Position set table"
}
Settings
1) 2)
Selection of the drive, parametrizing, programming the position sets ... (see chapter 4.2.4)
}
Axis type
}
SLTE_10_50_G04 Electric mini−slide type SLTE−10, stroke 50 mm, gear unit G04
}
yp
... ...
}
SLTE_16_150_G04 Electric mini−slide type SLTE−16, stroke 150 mm, gear unit G04
}
Axis parameters
}
Zero point
3)
Offset of axis zero point
}
p
}
SW−limit−neg
3)
Stroke limitation: Software end position, negative
}
SW−limit−pos
3)
Stroke limitation: Software end position, positive
}
SAVE... Save parameters in EEPROM
}
Homing paramet.
}
Homing method Selection of referencing method (stop, reference switch, etc.)
}
g p
}
Velocity v_rp Positioning speed for searching for the reference point
}
Velocity v_zp Positioning speed for moving to the axis zero point
}
SAVE... Save parameters in EEPROM
}
Position set
}
Position no. Number of the position set (1...31)
}
}
Pos set mode Set status: absolute or relative positioning
}
Position
3)
Target position of the position set
}
Velocity Positioning speed of the position set
}
Acceleration Acceleration for the position set
}
Deceleration Braking acceleration of the position set
}
SAVE... Save parameters in EEPROM
}
Password edit Setting up a local password with 3 figures for the control panel (see chapter 4.2.4).
}
HMI control
1)
Presetting the device control via the control panel (see chapter 4.2.3)
}
LCD adjustment Rotate the display in steps of 180°
1)
If necessary password protection
2)
Control interface must be deactivated, see [HMI control]: HMI=on
3)
Teach mode
Tab.4/3: Menu commands (overview)