Festo SFC-DC series, Manual

Page: 127 / 202

5. Commissioning
5−43
Festo P.BE−SFC−DC−IO−EN en 0801a
Please note
Make sure that:
the axis lies within the permitted positioning range when
it is switched on and before the start of reference travel.
that reference travel is carried out when the higher−order
controller or motor controller is switched on or, if appli
cable, after faults.
Device connection
Caution
The RS232 interface is not electrically isolated. It is in
tended for permanent connection to PC systems and not as
a control interface.
·
Use the connection only for parametrizing and
diagnosis.
Control in operation
Warning
Danger of injury.
Faults in parametrizing can cause injury to human beings
and damage to property if the controller is enabled with a
1−signal at the ENABLE input.
·
Enable the controller only if the axis system is correctly
installed and parametrized.
Caution
Note the manufacturer’s specifications for the permitted
operating conditions of the motors and drives used, e.g. in
respect of the permitted speeds.