Festo SFC-DC series, Manual

Page: 76 / 202

4. Control panel (only type SFC−DC−...−H2−...)
4−14
Festo P.BE−SFC−DC−IO−EN en 0801a
[Homing paramet.] Setting the referencing method and the speeds during the
reference run.
The maximum speed during the reference run is limited to
10mm/s.
[Hom. paramet.] Param. Manual
[Homing method] block negative Referencing to fixed stop,
negative = factory setting
block positive Referencing to fixed stop,
positive
switch negative Referencing to reference
switch, negative with
index search
switch positive Referencing to reference
switch, positive with
index search
[Velocity v_rp] v_rp Speed for searching for
the reference point
[Velocity v_zp] v_zp Speed for moving to the
axis zero point
[SAVE...] Save parameter in EEPROM
Please note
The set parameters become effective immediately after
confirmation with OK <ENTER>. The settings are saved
permanently in EEPROM with the menu command
[SAVE...]:
·
Save the parameter settings with the menu command
[SAVE]. Only then will the settings be retained even if the
power supply is switched off or if there is a power
failure.