Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 93 / 230

D 55
D_PL100
0RS_G
B
.f
m
5
5
-1
12
-
04
.0
7
Sensor message
After the activation message, the digital
controller briefly twice indicates the sen-
sor connected using an alternating dis-
play image. While this image is
displayed, the two direction lamps also
flash. The control then automatically
changes into operating mode.
$
If the sensor has been changed, the con-
troller continues to issue the alternating
sensor message until this message is
acknowledged (by pressing any button).
The operator should be reminded that
the sensor has been replaced and that
settings for the sensor should therefore
be checked.
Changeover between height sensor
and lateral slope
- Press the A/M button and the input key
several times at the same time until
the indicator switches between the ab-
breviation for sensor selection „S-S“
and identification of the active sensor.
SLo: Lateral slope sensor
rop: Height sensor
- Select the sensor required using the
UP/DOWN buttons.
- Confirm and return to operating mode
by again pressing the A/M button.
If no buttons are pressed, the controller
automatically switches back into operat-
ing mode after 5 sec.
Moba38.jpg
Moba_AM.Enter.bmp/Moba39.jpg/MobaSS.jpg