Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 114 / 230

D 76
D_PL100
0RS_G
B
.f
m
7
6
-1
12
-
04
.0
7
Auxiliary starting (electrical starting
aid)
If the batteries are flat and the starter is
not turning, the engine can be started
using an external source of power.
The following are suitable as sources of
power:
- another vehicle with a 24 V system;
- additional 24 V battery;
- starting aid, 20V/100A.
$
Normal charge devices and rapid charge
devices are not suitable as starting aids.
To externally start the engine:
- Connect power source to batteries lo-
cated behind flap at front of machine
using suitable cables.
$
Check correct polarity! Always connect
the negative cable last and remove it
first!
- Insert ignition key (4) in ignition lock in
setting „P“.
- Switch on ignition (Pos. 1).
- Turn ignition key in Pos. 2 to start the
diesel engine.
- Once the diesel engine fires, let go of the ignition key.
- The ignition key automatically jumps back into Pos. 1.
If the engine fails to start despite this starting aid: track down the cause, then proceed
in accordance with the engine's Operating Instructions if necessary.
Once the engine is running:
- disconnect external source of power.
When using starting aid spray, ensure fuel injection system is properly ventilated, as
defined in the engine's Operating Instructions.
Panel3_600.cdr,Iso600.wmf
P
0
I
II
4