Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 31 / 230

C 1
C_PL100
0RS_G
B
.f
m
1
-8 -
04.
07
C Transport
1 Safety regulations for transport
$
There is a risk of accident if the machine is prepared incorrectly and transportation is
conducted incorrectly
Prepare the machine ensuring that all components are secured and cannot come
loose. Dismantle all protruding and removable components and/or fit them so that
they do not represent a hazard!
Lower the machine until the bit tips on the milling drum are approx. 1 cm above the
ground, or if wooden supports are available, rest the tips gently on these.
The machine should be fastened onto the attachment points provided for this purpose
and fixed to the transporter in accordance with the relevant regulations.
Ensure that the transport vehicle is authorised for transport of this type and that the
maximum transport load is not exceeded.
Store all components which are not permanently connected to the machine in the
boxes and storage areas provided.
Close all panels and check that they are securely fastened.
When loading via ramps, there is a risk that the machine will slip, tilt or overturn. Note
wheelbase on 3-wheeled machines!
Drive carefully! Keep people away from the danger area!
The following applies in addition to the above during transport on public roads:
The machine operator must hold a valid driving license for this kind of vehicle.
The headlights must be set in accordance with the relevant regulations.
When driving on public roads, it may be necessary for someone to accompany the
machine operator to give directions - especially at crossroads and road junctions.
Note the load bearing capacity of vaults and bridges as well as the permissible trans-
port height and width.