Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 145 / 230

D 107
D_PL100
0RS_G
B
.f
m
1
07-
1
1
2 -
0
4
.0
7
444
YELLOW S232
1 620
1
Low voltage detected at OEM
harness 5 VDC supply
pin 10 of the OEM harness. Sensors connected to this +5 VDC
supply (i.e., remote throttle position
sensor) will not function.
488
YELLOW P105
0 105
0
Intake manifold air temperature
signal indicates intake manifold
air temperature is above the
minimum engine protection
threshold.
Power derate and possible engine
shutdown if engine protection shut-
down feature is enabled.
489
YELLOW P191
1 191
1
Auxiliary device speed signal on
pins 8 and 18 of the OEM har-
ness is out of range of the ECM
threshold.
Lose ability to control the speed of
the auxiliary device.
515
YELLOW P091
3 091
3
High voltage detected at the
coolant level +5 VDC sensor
supply voltage pin 49 of the en-
gine harness.
No engine protection for coolant
level.
516
YELLOW P091
4 091
4
Low voltage detected at the
coolant level +5 VDC sensor
supply voltage pin 49 of the en-
gine harness.
No engine protection for coolant
level.
517
YELLOW S251
12 1076
12
A mechanically stuck fuel control
valve has been detected by the
VP44 fuel pump controller.
Engine may shut down.
524
YELLOW P113
2 113
2
Error detected on the High
Speed Governor Droop selec-
tion switch input pin 24 of the
engine harness.
Operator can not select alternate
HSG Droop. Normal droop is used.
527*
YELLOW P154
3 702
3
Error detected in the Dual Out-
put Driver ”A” circuit pin 5 of the
OEM harness. The device controlled by the Dual
Output Driver ”A” signal will not
function properly.
528
YELLOW P093
2 093
2
Error detected on the Torque
Curve Selection switch input pin
39 of the OEM harness. Operator can not select alternate
torque curves. Normal torque curve
is used.
529*
YELLOW S051
3 703
3
Error detected in the Dual Out-
put Driver ”B” circuit pin 21 of
the engine harness. The device controlled by the Dual
Output Driver ”B” signal will not
function properly.
551
YELLOW P091
4 091
4
Idle validation signals on pins 25
and 26 of the OEM harness indi-
cate no voltage on either pin.
Engine will only idle.
599
RED S025
14 640
14
The dual output feature in the
customer specialised calibration
has initiated an engine shut-
down based on operating condi-
tions, engine sensor values, or
OEM inputs to the ECM.
Engine will shut down.
Error
code and
warning
lamp
PID(P)
SID(S)
FMI
SPN
(S)
FMI
Cause Effect