Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 97 / 230

D 59
D_PL100
0RS_G
B
.f
m
5
9
-1
12
-
04
.0
7
Connection:
The two digital controllers and the actual
value indicator, with a retaining knob on
its reverse side, are slid into their brack-
ets from above and are clearly visible
from the right side of the control panel on
the machine frame.
If disconnected, plug connections
should then be re-established.
- The two connection boxes (1) are lo-
cated directly beside the controller on
the underside of the machine frame, to
the left side of the milling drum hous-
ing. A connection between controller
and sensors is created via these two
sockets.
- The cable tension sensor for the side
board on the left side of the machine
(2) is also arranged at this location on
the underside of the machine frame.
- If required, the tension cable on the
sensor should be attached to the fas-
tening point (3) on the side board.
- In addition, the lateral slope sensor (4)
is located at this point. For connection
purposes, the rear socket is provided
on the left side of the housing.
- The cable tension sensor for the side
board of the right-hand side of the ma-
chine (5) can be found directly on the
machine frame above the board.
- If required, the tension cable on the
sensor should be attached to the fas-
tening point (6) on the side board.
Moba1can.cdr/Halt.jpg/Halt2.jpg
Seilzug1_PL600.wmf, Seilzug2_PL600.wmf
A
E
B
C
F
D