Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 16 / 230

B 4
B_PL100
0RS_G
B
.f
m
4
-18
- 04
.0
7
Milling depth adjustment: Milling depth adjustment is performed hydraulically, and
separately for each rear wheel.
To the left and right sides of the operator’s control station are two clearly legible mill-
ing depth indicators.
Traction system, steering system, travel drive, brake: Suspension of the two front
wheel using a parallelogram-shaped rocker arm ensures an optimum contact surface
at all times. The rear wheels on the chassis legs are designed for the milling adjust-
ment.
The right-hand chassis leg can be swivelled in front of the milling drum.
The hydraulic all-wheel travel drive has continuously variable adjustment across two
speed ranges. The hydraulic travel drives are connected to the wheel hubs by means
of planetary gears. This ensures optimum feed and high gradeability.
A multi-disc brake on the rear wheels acts as brake.
Water system: The water system comprises a water spraying and cooling system.
The water spraying and cooling system operates in the low pressure range. This sys-
tem is used for cooling and jetting the bits.
The spray nozzles can be easily replaced.
The water tank has a high capacity and has good access for filling from the top.
Hydraulic system : The drive unit, actuator functions and steering system are oper-
ated by independent hydraulic circuits ideally suited to the machine.
Electrical system: 24 volt system with two in-line cold-start high-performance batter-
ies and a 3-phase alternator.
The power supply can be interrupted to ground/earth by the battery’s main switch.