Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 163 / 230

F 9
F_PL10
00RS_G
B
.f
m
9-
76
-
04
.0
7
3.1 Power unit - engine
Fuel tank
The fuel tank should be filled before eve-
ry job to ensure that it does not run dry:
if this did happen, time-consuming and
costly bleeding of the fuel system would
be required.
Check fuel level at regular intervals us-
ing the display on the operating panel.
The tank neck (1) is located under the
right-hand flap on the engine compart-
ment.
This flap is opened using a square-sec-
tion wrench.
When filling the tank, ensure that no fuel
escapes into the ground. Switch off en-
gine and do not smoke. Do not fill tank in
confined spaces. Health hazard! Keep
fire extinguishers close at hand.
If there is any need for cleaning work
which requires the fuel tank to be emp-
tied, drain off all remaining fuel from the
tank.
The drain screw for this diesel fuel is lo-
cated on the right-hand side, underneath
the machine.
- To drain the fuel, first place a suitable receptacle under the drainage point, then re-
move the screw plug (2).
After draining the fuel, fit a new seal to the screw plug and tighten back into place.
Wear protective clothing when draining off diesel fuel.
Health hazard caused by contact with the skin.
Smoking and naked flame prohibited!
$
Never fill machine with dirty or contaminated fuel! Impurities in the fuel can cause se-
rious damage and may cause the engine to fail!
Wasserfilter_PL600new.wmf/Tankablass2_Pl600.tif
1
2