Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 194 / 230

F 40
F_PL10
00RS_G
B
.f
m
40-
7
6
-
0
4
.0
7
Side boards
Sliding shoes
The side boards which slide over the
ground (1) should be checked every 50
hours to ensure that they are still proper-
ly attached.
There is one side board on either side of
the milling drum housing.
The sliding shoes on the side boards are
in continuous sliding contact with the as-
phalt during planing operations, as a re-
sult of which they are subject to
increased levels of wear. Once the ma-
terial on these shoes becomes too thin,
the shoes have to be replaced.
Check the sliding shoes on both side
boards at regular intervals and replace if
required.
- Remove side board (1) A:
- Lower side board until it makes con-
tact with the ground.
- Unscrew stop plate (2).
- Disconnect the cable tension sensor
(3) if fitted.
- Remove the cables (4) used for rais-
ing and lowering the side board.
Eye bolts can be employed instead of
cables for restraining and raising the
side board after removal.
- Remove guide bolts (5).
- Cut the welded sliding shoes (6) off
the side board.
- Weld new sliding shoes firmly to the
side board.
Take all necessary safety precautions
during cutting and welding work!
Iso600.cdr,Box1_PL1000.cdr,Seitenschild2_PL1000.cdr
5
5
3
4
1
6
2