Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 140 / 230

D 102
D_PL100
0RS_G
B
.f
m
1
02-
1
1
2 -
0
4
.0
7
146
YELLOW P110
0 110
0
Coolant temperature signal indi-
cates coolant temperature has
exceeded the minimum engine
protection limit.
Power derate and possible engine
shutdown if engine protection shut-
down feature is enabled.
151
RED P110
0 110
0
Coolant temperature signal indi-
cates coolant temperature has
exceeded the maximum engine
protection limit.
Speed derate and possible engine
shutdown if engine protection shut-
down feature is enabled.
153
YELLOW P105
3 105
3
High voltage detected at intake
manifold temperature signal pin
34 of the engine harness.
Default value used for intake mani-
fold temperature.
No engine protection for intake
manifold temperature.
154
YELLOW P105
4 105
4
Low voltage detected at intake
manifold temperature signal pin
34 of the engine harness.
Default value used for intake mani-
fold temperature.
No engine protection for intake
manifold temperature.
155
RED P105
0 105
0
Intake manifold temperature sig-
nal indicates intake manifold
temperature is above the maxi-
mum engine protection limit.
Speed derate and possible engine
shutdown if engine protection shut-
down feature is enabled.
191
P050
11 876
11
A/C Clutch drive signal indicates
a short to ground when com-
manded on.
Can not turn on A/C.
234
RED P190
0 190
0
Engine speed signal indicates
engine speed has exceeded the
overspeed limit. Fuel to injectors disabled until en-
gine speed falls below the over-
speed limit.
235
MAINT. P111
1 111
1
Coolant level signal at pin 37 of
the engine harness indicates
coolant level is low. Power derate and possible engine
shutdown if engine shutdown fea-
ture is enabled.
241
YELLOW P084
2 084
2
Vehicle speed signal on pins 8
and 18 of the OEM harness has
been lost.
Engine speed limited to ”Max. En-
gine Speed without VSS”. Cruise
control, gear-down protection and
the road speed governor will not
work. Trip information data that is
based on mileage will be incorrect.
242
YELLOW P084
10 084
10
Invalid or inappropriate vehicle
speed signal indicated on pins 8
and 18 of the OEM harness indi-
cating connection or possible
tampering.
Engine speed limited to ”Max. En-
gine Speed without VSS”. Cruise
control, gear-down protection and
the road speed governor will not
work. Trip information data that is
based on mileage will be incorrect.
243
NONE P121
4 513
4
Error detected in the exhaust
brake relay enable control circuit
at pin 42 of the engine harness.
Exhaust brake will not work.
Error
code and
warning
lamp
PID(P)
SID(S)
FMI
SPN
(S)
FMI
Cause Effect