Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 115 / 230

D 77
D_PL100
0RS_G
B
.f
m
7
7
-1
12
-
04
.0
7
Allowing engine to „warm up“
To keep excessive wear and increased load of individual assemblies to a minimum,
the engine should always, but especially at low outside temperatures (<10°C), warm
up for approx. 5 minutes at idle speed and without any load.
The milling drum should be engaged.
The optimum operating values of a warm machine are:
- Coolant temperature of engine: 60°C
- Hydraulic oil temperature: 40°C
Take due note of visual signal from the
hydraulic system! If the indicator lamp
lights up (A), the milling operation must
be interrupted, or should not be en-
gaged.
Check hydraulic oil filter for signs of dirt,
and also check the oil level.
Before the milling procedure is started,
all hydraulic function elements on the
machine should be moved several
times.
Hydraulik_Pl600.tif
A