Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 108 / 230

D 70
D_PL100
0RS_G
B
.f
m
7
0
-1
12
-
04
.0
7
- Changing the controller over to lateral
slope is indicated in the display win-
dow by a lateral slope symbol and the
actual value of the planer / milling
drum’s lateral slope is shown as a %.
If the value displayed for lateral slop dif-
fers from the value previously measured
on the ground, the calibration must be
undertaken as follows:
Example:
The controller value displayed is correct-
ed to the value measured using the spirit
level as follows:
- The A/M button is used to change over
to manual mode, the „Auto“ function
lamp is off.
The display shows the actual value.
- Press and hold down the input key.
„SET“ appears on the display, then the
display changes again to the actual
value.
- The input key remains depressed and
the actual value is corrected to the val-
ue required (example 2.3) using the
UP/ DOWN buttons.
Only then release the input key! The val-
ue is saved automatically.
The actual value calibration should be conducted on both controls one after another.
Should the installation position of the Digi-Slope sensor have changed or should a
controller have been replaced, a new actual value calibration must be conducted in
both instances.
The actual value can be corrected at any time, i.e. even in automatic mode during
milling.
The actual value of the lateral slope is determined with the aid of a highly accurate
spirit level. It is measured right next to the milling drum box on the underside of the
machine frame as a %.
Moba1a.cdr
Moba21.jpg /Moba23.jpg/Moba25.jpg