Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 143 / 230

D 105
D_PL100
0RS_G
B
.f
m
1
05-
1
1
2 -
0
4
.0
7
376*
RED S233
13 1077
13 No calibration in the VP44 fuel
pump controller. Fueling to injectors disabled and
engine will shut down.
377
YELLOW S233
7 1077
7
VP44 fuel pump controller is not
powering down when key switch
power is removed from the
ECM.
Equipment batteries may be
drained low during long shutdown
periods.
381*
YELLOW S237
11 626
11
Error detected in cold start aid
relay 1 enable circuit at pin 41 of
the OEM harness.
Intake air heater can not be fully en-
ergised by the ECM.
Possible white smoke and/or hard
starting.
382*
YELLOW S237
11 626
11
Error detected in cold start aid
relay 2 enable circuit at pin 31 of
the OEM harness.
Intake air heater can not be fully en-
ergised by the ECM.
Possible white smoke and/or hard
starting.
385
YELLOW S232
3 620
3
High voltage detected at OEM
harness 5 VDC supply
pin 10 of the engine harness. Sensors connected to this +5 VDC
supply (i.e., remote throttle position
sensor) will not function.
386
YELLOW S232
3 620
3
High voltage detected at the en-
gine position 5 VDC
supply pin 10 of the engine har-
ness.
Default value used for sensors con-
nected to this +5 VDC supply.
Engine will derate to no-boost
fueling and loss of engine protec-
tion for oil pressure, intake manifold
temperature, and coolant tempera-
ture.
387
YELLOW P091
3 91
3
High voltage detected at the
throttle position 5 VDC
supply pin 29 of the OEM har-
ness. Engine idles when idle validation
switch indicates idle and ramps up
to a default set speed when idle val-
idation switch indicates off-idle.
391
YELLOW S017
11 632
11
Error detected in VP44 power
supply relay enable circuit at pin
43 of the engine harness.
Possible no effect on performance
or engine may not run.
415
RED P100
1 100
1
Oil pressure signal indicates oil
pressure below the very low en-
gine protection limit. Speed derate and possible engine
shutdown if engine protection shut-
down feature enabled.
418
WIF P097
0 097
0
Water-in-fuel signal indicates
the water in the fuel filter needs
to be drained.
Excessive water in the fuel can lead
to severe fuel system damage.
422
YELLOW P111
2 111
2
Voltage detected simultaneously
on both the coolant level high
and low signal pins 27 and 37 of
the engine harness ... OR ... no
voltage detected on either pin.
(Fault is active for Switch type
coolant level sensors only).
No engine protection for coolant
level.
Error
code and
warning
lamp
PID(P)
SID(S)
FMI
SPN
(S)
FMI
Cause Effect