Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 118 / 230

D 80
D_PL100
0RS_G
B
.f
m
8
0
-1
12
-
04
.0
7
Zero setting
- Run milling drum at low rotational
speed.
- Lower the planer until the bit tips
scratch the road surface across the
entire breadth of the milling drum.
- Set milling depth scales to zero.
The zero setting has to be undertaken
both when the chassis leg is swivelled
out and in! Always undertake the zero
setting on level ground which is not
sloped in any way.
Surface milling
1. With deployed right-hand chassis
leg:
The right-hand chassis leg engages in
the milled and cleaned first lane.
Depth setting:
- right - zero
- left - desired milling depth
2. With folded right-hand chassis leg:
(right-hand chassis leg runs in front
of milling drum along the lane which
has not yet been milled).
Necessary if space constraints prevent
the right-hand chassis leg from being
deployed or if the right-hand track does not have sufficient load-bearing capacity for
the vehicle.
Depth setting:
- Same milling depth on left and right sides
PL600_Back3.cdr
PL600_Back4.cdr