Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 173 / 230

F 19
F_PL10
00RS_G
B
.f
m
19-
7
6
-
0
4
.0
7
Suction-return hydraulic filter
The return line to the hydraulic filter is lo-
cated on the hydraulic oil tank behind the
left-hand maintenance flap on the en-
gine compartment. This maintenance
flap is opened using a square-section
wrench.
- Unfasten the filter housing cover (4)
by removing the square-section bolts.
- Remove the complete filter cartridge
from the housing.
- Remove handle (5) from the used filter
cartridge.
- Fit handle to the new filter cartridge
and install in the filter housing.
- Reinstall the filter housing cover (4)
properly.
Wear protective clothing when draining
hot oil. Health hazard caused by contact
with the skin.
$
Never clean and reuse the filter! Always
fit a new filter.
Send used filter for proper disposal.
Hydraulic hoses
$
Check the condition of the hydraulic hos-
es every 500 operating hours carefully.
Replace damaged hoses immediately.
Ageing hoses become porous and may
burst or split! Risk of accident!
A stamped number on their screw con-
nection provides information about the
date of manufacture (1) and also quotes
the maximum pressure limit (2) for this
hose.
Never install superimposed hoses and
always pay attention to the permitted
pressure limits.
Hydraulik_Pl600/Filter.tif
4
5
Hydraulik_PL600.tif
DHH 09/00 225BAR
1 2