Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 203 / 230

F 49
F_PL10
00RS_G
B
.f
m
49-
7
6
-
0
4
.0
7
Water filter
$
Replace the filter cartridge daily after
work, and whenever the contamination
indicator shows that this is necessary!
The machine’s accessories include an-
other water filter to daily replacement is
not a time-consuming operation.
The water filter is located behind the
right-hand maintenance flap of the en-
gine compartment.
The filter can be changed even if the wa-
ter tank has not been drained.
- Close stop cock (1) (lever in vertical
position).
- Unfasten filter housing (2) using the
wrench in the on-board toolkit and un-
screw by hand.
- Remove filter cartridge (3), also rinse
out housing and install a new / cleaned
filter.
- Clean the locating faces of upper and
lower housing sections and check the
gasket.
- Screw down filter housing by hand
and tighten gently using the wrench.
$
Ensure seal integrity is good after
changing the filter.
- Mesh size of main filter: 75 microns
The removed filter cartridge can be
cleaned and, if necessary, can be
flushed using a high pressure cleaner.
After the next time the machine is used,
the cleaned filter kit is then available to
replace the other filter.
Wasserfilter_PL600new.wmf/Wasser1_Pl600.tifWasserfilter2_single.tif
1
2
3