Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 105 / 230

D 67
D_PL100
0RS_G
B
.f
m
6
7
-1
12
-
04
.0
7
6.4 Calibration to zero
Initial situation for calibration to zero
- Sensors and controllers are fitted, all connection cables are connected.
- The machine is standing on a smooth, level surface without lateral slope, uniformly
lowered so that the milling drum is just slightly above the ground.
- The side boards are lowered
- The milling drum is activated, the diesel engine runs at idle speed.
- The moldboard is raised slightly and provides a clear line of sight to the rotating mill-
ing drum and the ground.
Other tasks
- Lower back of machine using the ap-
propriate function key on the control
panel without allowing the rotating
milling drum to make contact with the
ground.
- Move digital controller to „Manual“
(AUTO function lamp (M2) is off)
- Move levelling function for both ma-
chine sides to the „ON“ position.
- Use the buttons (M7) to slowly and
smoothly lower the left and right of the
machine until the entire width of the ro-
tating milling drum and the bit tips
scratch against the base.
- Both side boards locate flush with the
ground.
Nivellswitch500_1000.bmp /Moba1a.cdr
M2
M7