Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 111 / 230

D 73
D_PL100
0RS_G
B
.f
m
7
3
-1
12
-
04
.0
7
Checklist for machine operator
Once the maintenance and checking work listed in the maintenance manual has been
conducted at the specified intervals, the inspections and control work listed in the fol-
lowing list should also be noted and conducted.
This work is used to assess the machine status and to assure perfect operations as
well as personal safety.
If permitted by the operations in question, the checks should be conducted before,
during and after use.
Any defects found should be rectified immediately in compliance with the safety reg-
ulations.
In addition to the checklist, a visual check should be carried out of all components and
function settings.
Note the condition, fastening and wear of individual elements, completeness and
wear of milling tools as well as checking for specified settings, seal integrity and lu-
brication!
Check! How?
Emergency-stop button
- on main control panel
Check with engine running:
Engine must shut down immediately af-
ter actuation.
The button engages and must be pulled
out so that the engine can be started
again.
Horn
- On the operating panel Briefly press horn knob.
Horn signal must sound.
Lighting
-
Operating headlight
- Rotary beacons
- Hazard flasher
Lights must function,
keep headlight glass clean.
Steering system
Check with engine running:
Straight-ahead travel for machine,
steering responds synchronously to
steering wheel motion.
Travel drive
Check with engine running:
Machine accelerates, hesitates and
brakes smoothly both in the drive and
working gear.
Traction system - chassis leg
Check with engine running:
Smooth extension and retraction.
Safety switch
Fastening, check condition and func-
tion.
Water system
Check:
-
Function of spray nozzles.
Starter
Engine cannot be started unless:
-
drive lever is not in centre position
- milling drum is engaged
- actuator switch for chassis legs is
not in O position.
Other equipment:
- Engine panels
- Lateral flaps
Check that panels and flaps are secure.