Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 166 / 230

F 12
F_PL10
00RS_G
B
.f
m
12-
7
6
-
0
4
.0
7
Fuel filter
$
Replace the fuel filter every 500 operat-
ing hours.
The fuel filter is located behind the left-
hand flap on the engine compart-
ment.This flap is opened using a square-
section wrench.
Unfasten the electrical plugged connec-
tion (1) on the water sensor, unfasten
the filter using a filter key and clean the
supporting surfaces.
Fit new gasket, then fill new filter with fu-
el, tighten by hand then reconnect the
electrical plugged connection to the water sensor.
Send used filter for proper disposal.
$
Ensure seal integrity is good after changing the filter.
Follow advice in the instrucciones de uso del motor!
Draining water from the fuel filter
$
Drain water from the filter on a daily basis, as required.
Hold a suitable receptacle under the drain valve (2).
In order to drain off the water which has collected in the fuel filter, unscrew the water
drain valve (2) until all the water has drained out.
Send the drained mixture of water and diesel fuel away for proper disposal.
Avoid skin contact with fuel! Ensure that no fuel escapes into the ground!
Follow advice in the instrucciones de uso del motor!
Kraftstoff_PL1000.tif
2
1