Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 128 / 230

D 90
D_PL100
0RS_G
B
.f
m
9
0
-1
12
-
04
.0
7
- When in semi-automatic mode, set nominal value 0 on the two digital controllers
using the DOWN buttons (M7), activate the levelling unit using buttons (M8) on the
digital controllers (AUTO function lamp (M2) lights up), use switches (37) and (38)
on the main control panel to shift to „ON“ at the same time and while stationary, low-
er the machine to height zero.
At the start of feeding, use the DOWN buttons (M7) to slowly set the nominal value
and therefore continuously lower to the milling depth required.
- Set desired milling speed by adjusting the setting of the drive lever. The machine
starts to move when the drive lever moves out of its central position.
- If necessary, adjust the speed of the upper conveyor using the preselector.
- If necessary, guide the upper conveyor using the control lever.
The automatic function for water sprinkling and upper conveyor is engaged as soon
as the drive lever moves out of its central position and is disengaged automatically as
soon as the machine is stopped.