Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 130 / 230

D 92
D_PL100
0RS_G
B
.f
m
9
2
-1
12
-
04
.0
7
- Lower the machine to its zero cutting depth setting using switches (73), (74).
- Move the A/M buttons (M8) of both controllers to automatic mode (the AUTO func-
tion lamp (M2) lights up).
- Set the desired nominal values for each of the digital controllers using the UP/
DOWN pushbuttons (M6), (M7) (milling depth (here -8cm), lateral slope (here 2.6%
tilting downwards and to right side).
- To increase speed, deflect the drive lever slightly.
- Using the manual adjustment facility, lower the machine using switches (72), (74)
on the operating panel uniformly down to roughly the desired cutting depth (note
direction of „slope“)!
- Use switches (37) and (38) on the main control panel, to shift the levelling unit to
„automatic“. The machine now lowers to the values set.
- Set desired milling speed by adjusting the setting of the drive lever. The machine
starts to move when the drive lever moves out of its central position.
- If necessary, adjust the speed of the upper conveyor using the preselector.
- If necessary, guide the upper conveyor using the control lever (71).
The automatic function for water sprinkling and upper conveyor is engaged as soon
as the drive lever moves out of its central position and is disengaged automatically as
soon as the machine is stopped.
The lateral slope sensor is automatic provided that it is connected up!
During milling, both controllers must not be switched to lateral slope!