Dynapac PL 1000 RS, Operation & Maintenance Manual

Page: 47 / 230

D 9
D_PL100
0RS_G
B
.f
m
9
-1
12
- 04.
07
Item Designation Short description
24
Pressure control-
ler -relief pres-
sure
Moldboard
Pressure control for moldboard relief
To set the pressure at which the moldboard slides over
the milling lane.
The pressure setting determines the extent to
which the milling lane is cleared of milling debris.
25
Speed governor
on upper convey-
or
Used to adjust the discharge rate for cut material to
prevailing conditions (quantity of material involved, de-
livery speed).
This adjustment can also be made while the milling op-
eration is running.
Ensure that no cut material accidentally gets
„slung“ from the upper conveyor!
26
Engine speed ad-
juster
Infinitely variable adjustment of engine speed (provid-
ed that drive lever is fully deployed).
Min. setting: Idle speed
max. setting: Nominal speed
Automatic engine speed control keeps the
presset engine speed at the same level, even
when operating under load.
27
Preselection con-
troller
Travel drive This is used to set the target engine speed which
should be reached when the drive lever is fully de-
ployed.