ICS-2100 Installation Instructions
104
Doc. 065294-01 3/09
3. The flush solution is carried to the piston seal wash assembly and out to waste
via 1.5-mm (0.06-in) ID tubing (P/N 055847). Locate this tubing in the IC
system Ship Kit and cut the tubing into three unequal pieces in the following
lengths:
•
117 cm (46 in)
•
152 cm (60 in)
•
15 cm (6 in)
4. Install the tubing as follows (see
a.
Push the 117-cm (46-in) piece of clear tubing onto the drain tube on the
bottom of the
secondary
pump head. Place the free end of this tubing in
the flush bottle. Make sure the end of the tubing is near the bottom of the
bottle.
b. Push the 152-cm (60-in) piece of clear tubing onto the drain tube on the
top of the
primary
pump head. This is the waste line. Route this waste line
through the lower tubing chase and out the back of the IC system.
c.
Push the 15-cm (6-in) piece of clear tubing over the drain tube on the top
of the
secondary
pump head. Push the other end of the tubing over the
drain tube on the bottom of the
primary
pump head.
d. Place a 10 mL syringe (P/N 054578) at the end of the waste line, press the
syringe against the line to form a seal, and draw out all of the air.
Figure 103. Primary and Secondary Pump Heads with Drain Tubes
Secondary
Pump Head
Primary Pump
Head
Drain Tube
Drain Tube
(Not visible
in photo)
Drain Tube
Drain Tube
(Not visible
in photo)
