Setting Up the Eluent Generator
Doc. 065294-01 3/09
43
4. With the CR-TC oriented as shown in
, connect each line to
the corresponding port on the CR-TC.
NOTE To help retain the fittings and ferrules on the lines,
remove the coupler from each line just before
connecting the line to a port.
Figure 40. Plumbed CR-TC
5. Check that none of the lines are caught under the CR-TC and then
push the CR-TC onto the metal stud inside the EGC holder (see
). Push down until the CR-TC snaps into place.
Figure 41. CR-TC Installed in Holder
Regen Out
Regen In
Eluent
Eluent In
Out