Dionex ICS-2100, Installation Instructions Manual

Page: 69 / 110

Setting Up the Eluent Generator
Doc. 065294-01 3/09
65
3. Lift the EluGen
cartridge up slightly
from the EGC holder
and slide the EPM
bracket onto the side of
the holder (see
Figure 68 ).
Figure 68. EPM and Mounting Bracket Installed on EGC Holder
4. Connect the following lines to the EPM:
•
Connect the
TO CR-TC/EPM ELUENT OUT
line (yellow label) to
the
ELUENT OUT
port on the EPM (see Figure 69 ).
•
Connect the
TO CR-TC/EPM ELUENT IN
line (red label) to the
ELUENT IN
port on the EPM.
•
Connect the
TO CR-TC/EPM REGEN IN
line (orange label) to the
REGEN IN
port on the EPM.
•
Connect the
TO CR-TC/EPM REGEN OUT
line (blue label) to the
REGEN OUT
port on the EPM.
EGC Cable