Setting Up the Eluent Generator
Doc. 065294-01 3/09
75
Filling the EGC CO
3
Mixer with the Carbonate/Bicarbonate Eluent
Before initial use, follow the steps in this section to fill the EGC CO
3
Mixer with the carbonate/bicarbonate eluent concentration required for
the application to be run.
illustrates the liquid flow path through the eluent generator
components during initial filling of the EGC CO
3
Mixer with
carbonate/bicarbonate eluent.
Figure 78. EluGen Cartridge and EPM Plumbing for Initial Filling
of the EGC CO
3
Mixer with Carbonate/Bicarbonate Eluent
EGC
IN
TO DEGAS
ELUENT OUT
WASTE,
GAS
SEPARATOR
TO INJ
VALVE IN - P/
ELUENT OUT
EGC VENT
TO DEGAS
ELUENT IN
EGC
DEGAS
Connect to
Gas Separator
Assembly
Pre-plumbed
Pump Pulse
Damper
to
Inlet
Outlet
Send to waste
EGC CO
Mixer
3
EGC II
K CO
2
3
TO CR-TC/EPM
REGEN IN
(orange)
TO PUMP/
DAMPER
TO CR-TC/EPM
ELUENT OUT
(yellow)
TO
C
R-
TC
/E
PM
RE
GE
N
OU
T
(b
lue
)
EPM
E
L
UENT
I
N
T
O
C
R
-TC
/E
P
M
E
L
U
E
N
T
IN
(r
ed
)
EGC
OUT
(yellow)
(blue)
(red)
TO EGC CO3
MIXER IN
TO INJ VALVE
PORT P
TO EGC CO3
MIXER OUT
TO SRS/AES
REGEN OUT
Back-
Pressure
Coil*
*
14 MPa (2000 psi)
at 1.0 mL/min
