Dell PowerConnect W-7200 Series, Reference Manual

Page: 380 / 1538

380 | ip ospf Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
ip ospf
ip ospf area|{authentication message-digest | cost <cost> | dead-interval <seconds> | hello-
interval <seconds> | message-digest-key <keyid> <passwd> | priority <number> | retransmit-
interval <seconds> |transmit-delay <seconds>
Description
Configure OSPF on the VLAN interface.
Syntax
Parameter Description Range Default
area Enable OSPF on a specific interface by
entering the IP address of the router that will
use OSPF.
authentication message-digest
Set the OSPF authentication mode to
message digest. disabled
cost <cost>
Set the cost associated with the OSPF traffic
on an interface. 1 to 65535 1
dead-interval <seconds>
Set the elapse interval (seconds) since the
last hello-packet was received from the
router. After the interval elapses, the
neighboring routers declare the router dead. 1 to 65535
seconds 40
hello-interval <seconds>
Set the elapse interval (seconds) between
hello packets sent on the interface. 1 to 65535
seconds 10
message-digest-key <keyid>
<passwd>
Enable OSPF MD5 authentication and set the
key identification and a character string
password. <keyid> = 1
to 256 No default
priority <number> Set the priority number of the interface to
determine the DR. 0 to 255 1
retransmit-interval <seconds>
Set the retransmission time between link
state advertisements for adjacencies
belonging to the interface.
NOTE: Set the time interval long enough to
prevent unnecessary retransmissions. 1 to 65535
seconds 5
transmit-delay <seconds>
Set the elapse time before retransmitting link
state update packets on the interface. 1 to 65535
seconds 1
Usage Guidelines
When configuring OSPF over multiple vendors, use this command to ensure that all routers use the same cost.
Otherwise, OSPF may route improperly.