Dell PowerConnect W-7200 Series, Reference Manual

Page: 655 / 1538

show ap active
show ap active [ap-name <ap-name>|{arm-edge dot11a|dot11g|voip-only}|dot11a|dot11g|essid
<essid>|ip-addr <ip-addr>|ip6-addr <ip6-addr>|{type access-point|air-monitor|(sensor
dot11a|dot11g|voip-only)}|voip-only
Description
Show all active APs registered to a controller.
Syntax
Parameter Description
ap-name <ap-name> View data for an AP with a specified name.
arm-edge
Show the state of ARM edge APs.
dot11a
Show 802.11a radio information.
dot11g
Show 802.11g radio information.
voip-only Show AP information filtered by associated/active VoIP clients.
essid <essid>
View data for a specific ESSID (Extended Service Set Identifier). An
Extended Service Set Identifier (ESSID) is a alphanumeric name that
uniquely identifies a wireless network. If the name includes spaces, you
must enclose the ESSID in quotation marks.
ip-addr <ip-addr>
View data for an AP with a specified IP address by entering an IP address
in dotted-decimal format.
ip6-addr <ip6-addr>
View data for an AP with a specified IPv6 address.
type Show AP information filtered by type of AP.
access-point
Show information for Access Points only.
air-monitor
Show information for Air Monitors only.
sensor
Show only RFprotect Sensor information.
voip-only Show AP information filtered by associated/active VoIP clients.
Usage Guidelines
This command displays details for all active APs on the controller. If an AP on your network does not appear in this
table, it may have been classified as an inactive AP for any of the following reasons:
l
The AP is configured with a missing or incorrect VLAN. (For example, the AP is configured to use a tunneled
SSID of VLAN 2 but the controller doesn't have a VLAN 2.)
l
The AP has an unknown AP group.
l
The AP has a duplicate AP name.
l
An AP with an external antenna is not provisioned with external antenna gain settings.
l
Both radios on the AP are disabled.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap active | 655