Dell PowerConnect W-7200 Series, Reference Manual

Page: 1487 / 1538

Parameter Description Default
set in the
Measurement Report Mode field.
passive
Enables passive beacon measurement mode. In this mode, the client
sets a measurement duration timer, and, at the end of the measurement
duration, compiles all received beacons or probe response with the
requested SSID and BSSID into a measurement report.
NOTE: If a station doesn't support passive measurement mode, it returns
a Beacon Measurement Report with the
Incapable bit set in the
Measurement Report Mode field.
—
clone <profile-name> Copy settings from another specified 802.11k profile. —
bcn-req-chan-11a
This value is sent in the 'Channel' field of the beacon requests on the 'A'
radio. You can specify values in the range 34 to 165.
36
bcn-req-chan-11bg
This value is sent in the 'Channel' field of the Beacon Requests on the
'BG' radio. You can specify values in the range 1 to 14.
1
bcn-req-time
This option configures the time duration between two consecutive
beacon requests sent to a dot11K client. By default, the beacon requests
are sent to a dot11K client every 60 seconds. However, if a different
value is required, the
bcn-req-time
option can be used.
This permits values in the range from 10 seconds to 200 seconds.
60 seconds
dot11k-enable Enables the 802.11K feature. This feature is disabled by default. Disabled
force-dissasoc
This feature allows the AP to forcefully disassociate “on-hook” voice
clients (clients that are not on a call) after period of inactivity.
Without the forced disassociation feature, if an AP has reached its call
admission control limits and an on-hook voice client wants to start a
new call, that client may be denied. If forced disassociation is enabled,
those clients can associate to a neighboring AP that can fulfil their QoS
requirements.
This feature is disabled by default.
Disabled
handover-trigger-
profile
Name of the handover trigger profile associated with this 802.11k profile.
If the handover trigger feature is enabled in the handover trigger profile,
the controller will initiate the handover of a voice client (for example:
dual mode handsets) roaming at the edge of Wi-Fi coverage to an
alternate carrier or connection. The handover trigger is initiated if the
Wi-Fi signal strength reported by the voice client (received from all APs)
is equal to or less than the threshold value.
You must enable dot11k before using this command.
lm-req-time This option configures the time duration between two consecutive link
measurement requests sent to an dot11K client. By default, link
measurement requests are sent to a dot11K client every 61 seconds.
However, you can use the
lm-req-time
option to specify different
time interval.
This permits values in the range from 10 seconds to 200 seconds.
61 seconds
no
Negates or removes any configured parameter
rrm-ie-profile RRM IE Settings Profile
tsm-req-profile
TSM Report Request Settings Profile
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide wlan dot11k-profile | 1487