Dell PowerConnect W-7200 Series, Reference Manual

Page: 715 / 1538

show ap debug bss-config
show ap debug bss-config [ap-name <ap-name>|bssid <bssid>||essid <essid>|ip-addr <ip-
addr>|port <port>/<slot>]
Description
Show the configuration for each BSSID of an AP. This information can be used to troubleshoot problems on an AP.
Syntax
Parameter Description
ap-name <ap-name>
Filter the AP Config table by AP name.
bssid <bssid> Filter the AP Config table by BSSID. The Basic Service Set Identifier (BSSID) is usually the
AP’s MAC address.
essid <essid>
Filter the AP Config table by ESSID. An Extended Service Set Identifier (ESSID) is a
alphanumeric name that uniquely identifies a wireless network. If the name includes
spaces, you must enclose the ESSID in quotation marks.
ip-addr <ip-addr>
Filter the AP Config table by IP address by entering an IP address in dotted-decimal format.
port <port>/<slot>
Filter the AP Config table by port and slot numbers. The slot and port numbers should be
separated by a forward slash (/).
Examples
The output of this command shows the AP configuration table for a specific BSSID.
(host) #show ap debug bss-config
Dell AP Config Table
---------------------
bss ess vlan ip phy type fw-mode max-cl rates tx-rates preamble mtu
--- --- ---- -- --- ---- ------- ------ ----- -------- -------- ---
status wmm
------ ---
00:1a:1e:11:24:c2 cera2 66 10.6.1.203 g-HT ap tunnel 64 0x3 0xfff enable 0
enable enable
00:1a:1e:8d:5b:11 wpa2 65 10.6.1.198 a-HT ap tunnel 20 0x150 0xff0 - 0
enable enable
00:0b:86:9b:e5:60 guest 63 10.6.14.79 g ap tunnel 20 0x2 0x3fe enable 0
enable enable
00:1a:1e:97:e5:41 voip 66 10.6.1.199 g-HT ap tunnel 20 0xc 0x14c enable 0
enable enable
00:1a:1e:11:74:a1 voip 66 10.6.1.197 g-HT ap tunnel 20 0xc 0x14c enable 0
enable enable
00:1a:1e:11:5f:11 wpa2 65 10.6.1.200 a-HT ap tunnel 20 0x150 0xff0 - 0
enable enable
The output of this command includes the following information:
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap debug bss-config | 715