Dell PowerConnect W-7200 Series, Reference Manual

Page: 1538 / 1538

1538 | Appendix A: Command Modes Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
authentication Authentication
inservice Bring authentication server into service
ipv6 Internet Protocol Version 6
query-user Query User
test-server Test authentication server
user User commands
Config Mode
To move from enable mode to config mode, enter the command config terminal . Users in config mode may return
to enable mode at any time by entering the command exit .
When you are in config mode, (config) appears before the # prompt:
(host) (config) #
Some top-level commands have different sets of subcommands available in Enable or Config mode. To view a list of
available subcommands in Config mode, access the CLI in Config mode, enter the top level command, then enter a
question mark (?). For example, the following example shows which aaa commands are available in Config mode:
(host) (config) #aaa ?
alias-group Configure an Alias Group
authentication Authentication
authentication-server Authentication Servers
bandwidth-contract Configure bandwidth contract (256 Kbps - 2 Gbps)
derivation-rules Configure rules to derive user role or vlan
dns-query-interval Set DNS query interval
password-policy Password policy for locally configured management users
profile Configure an AAA Profile
radius-attributes Configure RADIUS attribute
server-group Configure a Server Group
tacacs-accounting Configure accounting
timers Configure authentication timers
user User commands
Configuration Sub-modes
Some Config mode commands can enter you into a sub-mode with a limited number of available commands specific
to that mode. When you are in a configuration sub-mode, the (config) that appears before the command prompt will
change to indicate your current mode; e.g (config-if) for config-interface mode, and (config-tunnel) for config-tunnel
mode.
You can exit a sub-command mode and return to the basic configuration mode at any time by entering the exit
command.