Dell PowerConnect W-7200 Series, Reference Manual

Page: 499 / 1538

reload
reload
Description
This command performs a reboot of the controller.
Syntax
No parameters.
Usage Guidelines
Use this command to reboot the controller if required after making configuration changes or under the guidance of
Dell Networks customer support. The
reload command powers down the controller, making it unavailable for
configuration. After the controller reboots, you can access it via a local console connected to the serial port, or
through an SSH, Telnet, or WebUI session. If you need to troubleshoot the controller during a reboot, use a local
console connection.
After you use the reload command, the controller prompts you for confirmation of this action. If you have not saved
your configuration, the controller returns the following message:
Do you want to save the configuration (y/n):
l
Enter y to save the configuration.
l
Enter n to not save the configuration.
l
Press [Enter] to exit the command without saving changes or rebooting the controller.
If your configuration has already been saved, the controller returns the following message:
Do you really want to reset the system(y/n):
l
Enter y to reboot the controller.
l
Enter n to cancel this action.
The command will timeout if you do not enter y or n.
Example
The following command assumes you have already saved your configuration and you must reboot the controller:
(host) (config) #reload
The controller returns the following messages:
Do you really want to reset the system(y/n): y
System will now restart!
...
Restarting system.
Command History
This command was introduced in ArubaOS 1.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config modes on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide reload | 499