Dell PowerConnect W-7200 Series, Reference Manual

Page: 709 / 1538

show ap database
show ap database {group <group>|inactive|indoor|local|long|outdoor|{page <page>}| sensors
[disconnected]|sort-by [ap-group|ap-ip|ap-type|fqln|provisioned|status {up|down}|switch-ip]
|sort-direction[ascending|descending]|start <start> |status {up|down]|switch <switch-ip-
addr>|unprovisioned|usb}
Description
Show the list of access points in the controller’s database.
Syntax
Parameter Description
group <group>
Show data for a specified AP group.
inactive
Show only local APs with no active BSSIDs or wired
AP interfaces.
indoor
Show only APs that have an installation mode set to “indoor.”
local Show only APs on this controller.
long
Display the following additional data columns:
l
Wired MAC Address,
l
Serial #
l
Slot/Port
l
FQLN
outdoor Show only APs that have an installation mode set to “outdoor.”
page <page>
Display a limited number of APs by entering the number of APs to be
displayed in the output of this command.
sensors
Show only RFprotect sensors.
disconnected Show only disconnected RFprotect sensors.
sort-by
Sort the output of this command by a specific data column.
ap-group
Sort by AP group name.
ap-ip
Sort by AP group name.
ap-type Sort by AP model.
fqln
Sort by Fully Qualified Location Name (FQLN).
provisioned
Sort by provisioning statistics.
status up|down
If used with the sort-by keyword, status sorts the output of the command by
status type (up or down.) Otherwise, use the status keyword to display APs
with the specified status.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap database | 709