Dell PowerConnect W-7200 Series, Reference Manual

Page: 698 / 1538

698 | show ap config Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description
Assignment Displays whether or not ARM channel and power
assignment has been enabled or disabled.
Allowed bands for 40MHz channels
Forty MHz channels may be used on the specified radio
bands (802.11a or 802.11g).
Client Aware Shows if the client aware feature has been enabled or
disabled for this AP. If enabled, AP will not change
channels when there are active clients.
Max Tx Power
Maximum transmission power for this AP, in dBm.
Min Tx Power Minimum transmission power for this AP, in dBm.
Multi Band Scan
Shows if the multi-band scan feature has been enabled or
disabled on this AP. If enabled, single-radio APs will try to
scan across bands for Rogue AP detection
Rogue AP Aware Shows if the rogue AP awareness feature has been enabled
or disabled on this AP. If enabled, the AP will try to contain
off-channel Rogue APs
Scan Interval
This column indicates, in seconds, how often the AP will
leave its current channel to scan other channels in the band
if scanning is enabled
Active Scan
Displays whether or not the active scan feature is enabled.
NOTE: This option elicits more information from nearby APs,
but also creates additional management traffic on the
network. Active Scan is disabled by default, and should
not
be enabled except under the direct supervision of Dell
Support.
Scanning Shows if scanning is enabled or disabled for this AP. If this
option is disabled, the following other options will also be
disabled:
l
Multi Band Scan
l
Rogue AP Aware
l
Voip Aware Scan
l
Power Save Scan
Scan Time
The amount of time, in milliseconds, an AP will drift out of
the current channel to scan another channel. The supported
range for this setting is 0-2,147,483,647 seconds. Best
practices are to configure a scan time between 50-200
msec.
VoIP Aware Scan
Shows if VoIP aware scanning is enabled or disabled. If
you use voice handsets in the WLAN, VoIP Aware Scan
should be enabled in the ARM profile so the AP will not
attempt to scan a different channel if one of its clients has
an active VoIP call. This option requires that Scanning is
also enabled.
Power Save Aware Scan Shows if the power save aware scan is enabled or
disabled. If enabled, the AP will not scan a different
channel if it has one or more clients and is in power save
mode.