Daikin D-BACS, Design Manual

Page: 364 / 376

2.5 <DTA103A51> Wiring Adaptor for Other Air Conditioners 347
Adaptor
<Setting Group No. for Centralized Control>
Set the group No. at the central control group No. setting switches (RS1 and RS2). Refer to the below table to set
group No. Group No. increases in the order of 1-00, 1-01 ... 1-15, 2-00, ... 4-15. Refer to the installation manual of the
optional controller.
RS1 Switch Setting and Upper Group No. Position
RS2 Switch Setting and Lower Group No. Position
Make Settings before Turning ON The Power.
Note:
Group number need not be set on this adaptor during individual use with either a wiring adaptor for electrical appendices
or a schedule timer. Setting is automatic.
Ex. Setting group No. 1-15
First and second group No.s are indicated as below.
<Power Supply Wiring>
Power supply can be selected from a 1
~
50 Hz 220-240V source and a 1
~
60 Hz 220V source. Check power supply
specifications and properly wire the source to the adaptor.
Note:
„
Ground wires as shown in the figure on the right.
„
The adaptor may malfunction or be damaged if improperly wired.
„
The fuse is designed for short-circuit protection (Overcurrent protection).
Therefore, it may not offer sufficient protection against improper voltage.
2PA53853
Position 0 1 2 3 4 5 6 7 8 9
Group No. — 1 2 3 4 — — — — —
Position 0 1 2 3 4 5 6 7 8 9 A B C D E F
Group No. 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15