Daikin D-BACS, Design Manual

Page: 357 / 376

340 2.4 <DTA107A55> Central Control Adaptor Kit
Adaptor
2.4.2 Part Names
2.4.3 Installation
X2M X1M
COMPONENTS
Check the following components are included in this optional accessory before installation.
Give to the customer this OPERATION MANUAL certainly.
INSTALLATION MANUAL WIRE HARNESS
OPERATION MANUAL
CONTROL BOARD BOX
INSTALLATION
Deside the situation of Control Board Box.
It is affected the situations of the thermistor.
The length of lead wire - Thermistor : 2.5m
Install the thermistor (in the control board box) at the inlet
duct or the suction grille.
Use the kit : remote sensor (KRCS01-1), if you need the longer
length than it. (Can use it untill 12m.)
Install the control board box on the wall or the pillar.
Make sure the wire inlet is at the bottom of the box.
Use 4 bolts (M5) for fixing the box.
Install the box in the indoor side.
(Example : Set it in the ceiling or in the room.)
Do not install the box in the air conditioner.
Fixing situation : See right Fig. (Height : 125mm)
(*shows the fixing pich.)
*215
*390
372
410
301
(304)
26
125mm
SURVICE SPACE
350mm
or more
Example : Set the thermistor into the
inlet duct and clamped by
resin clamp and fix plate.