DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
485
Chapter 46
Link Layer Discovery
Protocol (LLDP) Command
List
enable lldp
disable lldp
config lldp
[message_tx_interval <sec 5-32768> | message_tx_hold_multiplier <int 2-10> |
tx_delay <sec 1-8192> | reinit_delay <sec 1-10>]
config lldp notification_interval
<sec 5-3600>
config lldp ports
[<portlist> | all] [notification [enable | disable] | admin_status [tx_only | rx_only |
tx_and_rx | disable] | mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable | disable] | basic_tlvs
[{all} | {port_description | system_name | system_description | system_capabilities}] [enable |
disable] | dot1_tlv_pvid [enable| disable] | dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] |
vlanid <vidlist>] [enable | disable] | dot1_tlv_vlan_name [vlan [all | <vlan_name 32>] | vlanid
<vidlist>] [enable | disable] | dot1_tlv_protocol_identity [all | {eapol | lacp | gvrp | stp }] [enable |
disable] | dot3_tlvs [{all} | {mac_phy_configuration_status | link_aggregation |
power_via_mdi|maximum_frame_size}] [enable | disable]]
config lldp forward_message
[enable | disable]
show lldp
show lldp mgt_addr
{[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
show lldp ports
{<portlist>}
show lldp local_ports
{<portlist>} {mode [brief | normal | detailed]}
show lldp remote_ports
{<portlist>} {mode [brief | normal | detailed]}
show lldp statistics
show lldp statistics ports
{<portlist>}
config lldp_med fast_start repeat_count
<value 1 - 10>
config lldp_med log state
[enable | disable]
config lldp_med notification topo_change ports
[<portlist> | all] state [enable | disable]
config lldp_med ports
[<portlist> | all] med_transmit_capabilities [all | {capabilities |
network_policy | power_pse | inventory}] state [enable | disable]
show lldp_med ports
{<portlist>}
show lldp_med
show lldp_med local_ports
{<portlist>}
show lldp_med remote_ports
{<portlist>}
enable lldp
46-1
Description
This command is used to globally enable the LLDP function.
When this function is enabled, the Switch can start to transmit LLDP packets and receive and
process the LLDP packets. The specific function of each port will depend on the per-port LLDP
setting.
For the advertisement of LLDP packets, the Switch announces the information to its neighbor
through ports. For the receiving of LLDP packets, the Switch will learn the information from the
LLDP packets advertised from the neighbor in the neighbor table. The default state for LLDP is
disabled.
Summary of Contents for DGS-3000 series
Page 1: ......